Then you have a set of the earlier stacks I have made. I made these as I saw a few pics of the HRC stacks on the SpeedZilla forum. They have the flatter top (and the dimples....). I started making stacks in Delrin (lighter than aluminium !) but was asked to make them in alu and was also asked to make the radii bigger. I think I went from 6mm radius to 10mm and finally to the 12,5mm radius I am using at the moment but it took me a long time to find a bigger radius end mill and a mt2 adapter to fit my small mill.
SP1:PVM mag.,full Akra,Durbahn airbox,T1 G2 snorkel,SpeedCell,SP2 swing+mod. subfr.+engine cover,WP susp. +TiN,endur. fairing VFR400 headlight,KYA fronts, Setrab oilcooler,MR clipons,flowed throttlebod.,lightened flywheel, Moriwaki rests, Delrin stacks,BKG triple clamps,PC II,Ti bolts, qr seat+tank,Durbahn/ISR rear brake,Durbahn CCC,AFAM 15-41, DID520,CBR600RR coils,50310 fan switch,mod. wire harness,HRC overflow,Extreme Graphics undertray,Harris fairing stay.
Last edited by SPeter1; 09-26-2017 at 02:24 AM.