Join Date: Aug 2013
Location: Woodland Park, CO.
Mentioned: 0 Post(s)
Quoted: 0 Post(s)
O-Ring / Gasket replacement for Relief Valve and Oil Strainer
So, I dropped the oil pan to perform a complete cleaning. Pulled the Relief Valve and Oil Strainer to give them a good kerosene cleaning. O-Ring/Gasket looked fine. The shop manual says to "replace". I put them back in without replacing. Is this going to be a problem?? They went back in just fine. I'm afraid they are going to drop out though. Should I pull the pan back off and replace the O-Ring/Gasket??
Oh yea, this is a 2000 RC51
Last edited by Sabre1; 08-19-2013 at 03:56 PM.
Reason: added year and model of motorcycle