RC51 Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
176 Posts
Discussion Starter #1
It is with DEEP DEEP regret that I am selling my SP-1 Race bike. I have Tried to compete in the UK Club Thundersport, Golden Era series. But my dumb wife keeps popping babies out. so I've never managed more than 4 races in a season. So it has had very light use and lived a pampered lifestyle.

The bike was fully disassembled and each part was cleaned and modified as best I could to get it as light as I could for racing. It is a UK bike and comes with a clean V5 so could be put back on the road if you were that way inclined, but I wouldn’t advise it(wasted!!)

The bike has got quite a decent spec. So much so, that I will probably forget to mention some things. but anything I miss off, if sure you keen eyed lot will pick up on it. so here goes...

From back to front;
Honda SP2 rear wheel
Racetorx chain adjusters
Braced swingarm
GPR high level race cans
Modified SP2 rear subframe
Condensed wiring harness
Harris adjustable Rearsets
Yamaha R6 hugger
Penske 2 way adjustable bespoke rear shock with spring for 11.5st rider(revolution racing bespoke)
Power commander 3
lightweight LIPO battery
Titanium bolts, nuts and fasteners throughout
Engine was replaced for a 3,000mile one and stripped and refreshed
Recent top end engine refresh with anti-lash gears removed
CBR1000 stick coil modification
Denso Iridium IK27 plugs
Hopes and dreams
Honda Smog/Pairs system removed and blanking plates installed
Dry break fuel lines
Modified airbox/filter element removal
Durbahn carbon inlet snorkel
HRC fuel and coolant overflow reservoirs with HRC breather valve
Custom front mount Radiator kit - including pipework and large Mocal oilcooler with braided lines(very expensive and effective) Carbon brackets and mounts
Modified thermostat housing(stat removed)
Samco race coolant hoses
Deluded prospects that I could sustain racing with offspring
Racetech springs and Racetech Gold valve fork internals
HRC quick action throttle
Brembo RCS x2 ratio master cylinder
Bespoke goodridge braided race lines(twin lines)
New Brembo Race soft bite pads
Motul Racing brake fluid(same used in MotoGP)
Goodridge braided clutch Lines
Brembo master cylinder
Basic lap timer
Bitter resentment of my wife
Double bubble screen(dark tint and clear)
Carbon front fender
Carbon clutch and Geni covers
Dymag front wheel
Dunlop KR108/106 race tyres. Only 3 heat cycles with plenty of life left in them
Harris fairing bracket
Ricambi Weiss fairing with self supporting seat unit and seat foam

I'll add more pics later today
 

Attachments

1 - 4 of 4 Posts
Top