RC51 Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
351 Posts
Discussion Starter #1
This morning when I started up my bike .. it stalled a few times ....later down the road I filled it up with gas..and it ran great for 50 miles ...and parked the bike on the ferry to bring me over the James River to Williamsburg, VA .
later when I tried to start the bike ..the engine stalled over and over...and the F1 light gave me 8 flashes ..( TP Sensor )
I disconnected the battery for a few minutes ..and after I connected the battery again ..it fired right up ..and I flew home ..before it would stall again..

At home I lifted the Gas Tank and disconnected the 2 grey connectors and cleaned them ...No Luck ...it still gives me 8 flashes .:)

is this a job for the Stealer Ship ?
 

·
Registered
Joined
·
351 Posts
Discussion Starter #2
A member from a Different board told me to disconnect the Power Commander.

I disconnected it ..and the bike fires right up with no F1 Light.

is the PC Bad or can you reset them ?
 

·
Registered
Joined
·
351 Posts
Discussion Starter #4
I took the bike this morning for a fast 80 mile run over the back roads ...and I don't think I will purchase a New Power Commander.
 
1 - 4 of 4 Posts
Top