RC51 Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Good day fellow RC'ers. Purchased my baby about 3 months ago, have been burning fuel to the tune of 70 miles to a tank. I am sure I should be getting closer to 150!

I have check the all connections to the gas tank to make sure there are not any pinched lines. Nothing out of the ordinary. However after reading a few forms I have noticed that the previous owner did remove the FLAPPER MOD. I have only heard of this done on race bikes. Could this be my problem. I did notice after popping the tank off that there are lines that are plugged by screws and 2 plugs that are not attached to anything. Please advise!!!!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top