RC51 Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
128 Posts
Discussion Starter #1
So I got new CRG roll a click folding levers and new LSL clip ons. One major problem I am having is finding the proper clearance when trying to line up everything. The CRG levers stick out more than the stock levers and either hit on my upper fairing. If I adjust the angle of the clip ons they hit/get too close to the tank on a full turn. Serious issue that's preventing me from getting my girl on the road. Anyone else have this issue? Any advice/recommendations?

Also, I have a shogun frame slider kit. I was able to get the bolt off the right side, but the left side looks like some type of locking nut and I can't move that thing the save my life. Is there a special tool for this bolt? It looks a bit odd. The inner Hex head is stripped.... FML....

Project bike is killing me right now.


-Kyle
 

·
Registered
Joined
·
128 Posts
Discussion Starter #3
I'll grab a photo tonight or tomorrow. I've put a lot of work into it so far and so close to being done. Just a lot of little adjustments etc to finish up with.
 
1 - 3 of 3 Posts
Top