RC51 Forums banner

1 - 8 of 8 Posts

·
Premium Member
Joined
·
213 Posts
Discussion Starter #1
anyone out there have a set of Giles lifters that they are not using? I have the chain adjusters but am looking for just the lifters. If so shoot me a PM. Thanks.
 

·
Premium Member
Joined
·
213 Posts
Discussion Starter #3
I did see that there was an add that said both the racetorx and Giles were compatible. So that would work too.
 

·
Registered
Joined
·
523 Posts
I have an unused set of Racetorx lifters that came with his 1st gen adjustors.
Provisionally fitted for the picture only, not a scratch or mark on them.

I measure the hole distance at 30mm.

PM me if you are interested in these BTopp

 

·
Premium Member
Joined
·
213 Posts
Discussion Starter #6
I sent you a PM. I will check today after I get off of work to confirm the 30mm spacing.
 

·
Premium Member
Joined
·
98 Posts
I have a set of racetorx lifters as well...they are yours if you want them.
 
1 - 8 of 8 Posts
Top