RC51 Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
50 Posts
Discussion Starter #1 (Edited)
Sold, plz delete

SOLD!!!I have a set of Carbon Fiber slip on cans that came off of my 2001 RC. The right side can is missing the Micron badge and the rubber clamp spacers are starting to dry rot. I have never laid the bike over, so there is no damage to either can. $185 shipped. I am located in Houston,Texas if anyone wants to see them in person or for local pick up.









 

·
Registered
Joined
·
8,663 Posts
How many miles did they see? They look nice. Might be a dumb question, just not to knowledgable on this, but what about midpipes for a stock system like mine?
 

·
Registered
Joined
·
50 Posts
Discussion Starter #3
How many miles did they see? They look nice. Might be a dumb question, just not to knowledgable on this, but what about midpipes for a stock system like mine?
I'm actually keeping the mids that go to these, but I know you can find some out there somewhere. I'm sure you don't have to use Micron mids, just as long as the diameter matches up. These pipes have around 3500 miles on them.
 

·
Registered
Joined
·
8,663 Posts
Bet they'd look good with the sato mids that were on ebay recently. I have a stock system sp1. Looking for just the right sp2 cans and mids, then my sp1/sp2 frankenstein header project begins.

Anyway, good luck and thanks for the answer.
 
1 - 6 of 6 Posts
Top