RC51 Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I need to know if anyone can walk me through how to reset the tilt sensor on my RC51; i high-sided, slid the bike about 100 feet and can't get the engine to turn over. Coil, fuse, plugs and fuel line are all good, fuel pump turns on with ignition, but no fuel or spark.
 

·
Registered
Joined
·
2 Posts
on most bikes with a tilt sensor, you have to hit the kill switch to the off position, then back on... then turn the keey off, then back on... and it should start up
 

·
Registered
Joined
·
7 Posts
Any idears would a tilt sensor still let the bike crank but not start. Bike primes cranks just won't start. I put u deepest on and all wires ecu were a pain get back on. I checked everything I cannot see why it won't start. It started fine a week ago. It has a new battery power commander was already on it Would tilt sensor cause this ? Or have I disturbed a cable. Everything is how it should no f1 lights primes fuel pump cranks but nothing thanks
 
1 - 4 of 4 Posts
Top