RC51 Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hey,
New to the forum! I just picked up a 05 and need to swap the subframe. My T50 bit is sloppy on the subframe bolts and a t55 is to large??? I've always been a suzuki guy.....please tell me Honda didn't make some "special tool" or size for these bolts. Cheers
 

·
Registered
Joined
·
170 Posts
I'm pretty sure it's a T50. Whatever you do, don't strip it out. And if you strip it out, don't break off the extractor in the screw hole after drilling it out. Don't ask me how I know all that.
 

·
Registered
Joined
·
3 Posts
Discussion Starter #3
Thanks for the reply watskooo,
Maybe someone has already tried a t45 on them, they do look a little rounded out. I ordered a new subframe so I'm going cut it off leaving 4 tabs on the ends of the bolts that will hopefully spin off like nuts and release the subframe bolts. I'm assuming they are not threaded throught the frame also.
 
1 - 3 of 3 Posts
Top